Robo R2¶
Installation and User Manual
- General Safety Information
- Getting Started
- Operation
- Maintenance
- Troubleshooting
- Print Not Sticking to Bed
- Grinding Noise when Starting a Print
- Material Not Extruding
- Shifting Layers/bad print quality
- Hotend Clogged
- Hotend Falling Out
- Screens Goes unresponsive or Doesn’t Work
- Hotend Cover is falling off
- Drive Gear aligning and tightening
- Filament Runout Sensor Error
- Firmware Update
- Checking your Pogo Pins
- Print Bed Pogo Pin Connection Replacing
- Z-Limit Switch Replacing
- Door Replacement
- Error Messages
Robo™ R2 User Manual by Robo 3D, Inc. Copyright © 2017 Robo 3D, Inc. Permission is granted to copy, distribute and/or modify this document under the terms of the Creative Commons Attribution 4.0 International Public License (CC BY-SA 4.0). Published by Robo 3D, Inc., 5070 Santa Fe Street Suite C, San Diego, California, 92109 USA.