• General Safety Information
• Getting Started
  • What’s in the box
  • Unboxing Robo C2
  • Register your Robo C2
  • Initial set-up
  • Connecting to Wi-Fi
  • Updating Robo C2
  • Calibration and setting Z offset
  • Loading filament
  • The test print
  • Removing the test print
  • Using Hotspot Mode
• Operation
  • Display Screen
  • Setting the Z offset
  • Loading and Unloading Filament
  • Start a print
  • Print Status
  • Using print bed adhesion
  • Removing the print
  • Setting Up Wifi
  • Downloading the Robo App
  • Connecting your iOS device to your Robo C2
  • Updating Your Printer
• Maintenance
  • Be sure to check for the following before every print:
  • Cleaning the feeder gear
  • Lubricating the axis
  • Cleaning the print bed surface
  • Replacing your Hotend Nozzle
• Troubleshooting
  • Print Not Sticking to Bed
  • Grinding Noise when Starting a Print
  • Material Not Extruding
  • Shifting Layers/bad print quality
  • Hotend Clogged
  • Hotend Falling Out
  • Drive Gear aligning and tightening
  • Screens Goes White or Doesn’t Work
  • Hotend Cover is falling off
  • Filament Runout Sensor Error
  • Firmware Update
  • Error Messages

Robo™ C2 User Manual by Robo 3D, Inc. Copyright © 2017 Robo 3D, Inc. Permission is granted to copy, distribute and/or modify this document under the terms of the Creative Commons Attribution 4.0 International Public License (CC BY-SA 4.0). Published by Robo 3D, Inc., 5070 Santa Fe Street Suite C, San Diego, California, 92109 USA.